Skip to content

AU

FREE SHIPPING ON ORDERS OVER $550 IN SELECTED AREAS

103164252_7921426838.jpg

D-Link DGS-F1210-26MPS-E network switch Managed L2 Gigabit Ethernet (10/100/1000) Power over Ethernet (PoE) Grey

Regular price $1,390.87
Sale price Regular price

Key specifications

  • Product colour: Grey
  • Switch type: Managed
  • Operating temperature (T-T): 0 - 40 °C
  • Operating relative humidity (H-H): 10 - 90%
  • Networking standards: IEEE 802.1D, IEEE 802.1Q, IEEE 802.1af, IEEE 802.1p, IEEE 802.1s, IEEE 802.1w, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3at, IEEE 802.3i, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z
  • Basic switching RJ-45 Ethernet ports quantity: 24
  • Basic switching RJ-45 Ethernet ports type: Gigabit Ethernet (10/100/1000)
  • Power over Ethernet (PoE): Yes
  • Switching capacity: 52 Gbit/s
  • MAC address table: 8000 entries
  • 10G support: No
  • Storage relative humidity (H-H): 10 - 95%
  • LED indicators: PoE, Power, System
  • Quality of Service (QoS) support: Yes
  • Rack mounting: Yes
  • Flow control support: Yes
  • Jumbo frames support: Yes
  • Switch layer: L2
  • Forwarding rate: 38.7 Mpps
  • Jumbo frames: 10000

Data transmission

Number of queues
8

Design

Number of fans
3 fan(s)

Management features

ARP inspection
Yes
Configuring Location Settings (CLI)
Yes
System event log
Yes
Traffic classification
Yes
Web-based management
Yes

Multicast features

Multicast features
Interface-based multicast traffic statistics
Multicast support
Yes

Network

Active link detection
Yes
Auto-negotiation
Yes
Cable types supported
Cat5e
Ethernet LAN data rates
10,100,1000 Mbit/s
Link aggregation
Yes
MAC address auto-aging supported
Yes
MAC address auto-learning supported
Yes
Number of VLANs
4000
Port mirroring
Yes
Rate limiting
Yes
Spanning tree protocol
Yes
VLAN support
Yes

Operational conditions

Storage temperature (T-T)
-20 - 70 °C

Performance

Noise level
45 dB

Ports & interfaces

Console port
RJ-45
Power connector
AC-in jack
SFP module slots quantity
2

Power

AC input frequency
50 - 60 Hz
AC input voltage
100 - 240 V
Number of power supply units
1
Power consumption (max)
400 W
Power consumption (typical)
18 W
Power source
AC
Power supply included
Yes

Power over Ethernet (PoE)

Power over Ethernet (PoE) power per port
30 W
Power over Ethernet plus (PoE+) ports quantity
8
Total Power over Ethernet (PoE) budget
380 W

Protocols

Supported network protocols
IPv4, IPv6

Security

Authentication
Port-based authentication
Authentication type
IEEE 802.1x
BPDU filtering/protection
Yes
DHCP features
DHCP snooping
IGMP snooping
Yes
IP-MAC-Port binding
Yes
Loop protection
Yes
MAC address entries
Dynamic MAC address entries, Static MAC address entries
Password protection
Yes
Queue scheduling algorithms
SP, WFQ, Weighted Round Robin (WRR)
Security algorithms
HTTPS, SSH
SSH/SSL support
Yes

Weight & dimensions

Depth
29.3 cm
Height
4.4 cm
Weight
5 kg
Width
44 cm

THE NUTEC ADVANTAGE

VENDOR NEUTRAL

Advice focused on the solution that best fits your business needs.

END TO END DELIVERY

From selection through implementation, support, and beyond.

BUSINESS FIRST OUTCOMES

Delivering solutions focused on measurable outcomes.

LONG TERM PARTNERSHIP

Built on trust, support, and shared success.

Compare With Similar Items

Description
The D-Link DGS-F1210 Series Smart Managed Switches are the latest generation of switches to provide increased Power over Ethernet (PoE) output, a range of physical interface types, multiple management interfaces, and advanced Layer 2 features. With all of these features combined, the DGS-F1210 Series provide a cost-efficient and flexible solution for expanding any business network.

PoE Support
The DGS-F1210 Series switches provide Power over Ethernet (PoE) support, reducing deployment time for IP cameras, VoIP phones, and access points. Dedicated power adapters are no longer required, as the DGS-F1210 Series switches comply with IEEE 802.3af (PoE) and 802.3at (PoE+) standards and provide up to 30 watts per port. The DGS-F1210-26MPS-E model offers extended PoE budget of up to 380 Watts. Additionally, 8 PoE ports in each switch offer Long Reach PoE technology1, allowing the use of longer network cable runs which are normally limited to 100m. The Long Reach PoE technology supports cables up to 250m long.

Seamless Integration
The DGS-F1210 Series support a range of port and media types, including 10/100/1000BASE-T RJ-45 ports, PoE and PoE+ and Gigabit SFP ports. The DGS-F1210-10PS-E, DGS-F1210-18PS-E, DGS-F1210-26PS-E and DGS-F1210-26MPS-E models feature 2 SFP ports allowing you to choose the most suitable media type for your requirements. All DGS-F1210 Series switches include support for IEEE 802.3af/at and high power budgets, allowing more PoE devices to be powered by the switch and for devices to be installed in remote locations without immediate access to power outlets.

The DGS-F1210 Series come equipped with a complete line-up of Layer 2 features, including IGMP snooping, port mirroring, Spanning Tree Protocol (STP), and Link Aggregation Control Protocol (LACP). The IEEE 802.3x Flow Control function allows servers to directly connect to the switch for
fast, reliable data transfers. The DGS-F1210 Series also support advanced features such as port segmentation, which allow network administrators to divide the network into VLANs, increasing network efficiency. Network maintenance features include loop detection and cable diagnostics.
Loop detection significantly speeds up troubleshooting by automatically detecting and shutting down switching loops. The cable diagnostics feature, designed primarily for administrators and customer service representatives, determines the cable quality and quickly discovers errors, allowing for hassle-free diagnostics and maintenance.

The DGS-F1210 Series support 802.1X port-based authentication, allowing the clients to be authenticated through external RADIUS servers. The Access Control List (ACL) feature helps to enhance network security and helps to protect the internal IT network. The DGS-F1210 Series also
feature Address Resolution Protocol (ARP) spoofing prevention, which helps to provide protection from attacks on the network that could allow an intruder to sniff data frames, modify traffic, or bring traffic to a halt altogether by sending fake ARP messages. To help prevent ARP spoofing attacks, the switch uses packet control ACLs to block invalid packets that contain fake ARP messages. The DHCP Snooping feature filters DHCP replies on unauthorised ports to prevent them from being assigned an IP address.
DGS-F1010P-E is 10 port 1Gps with 8 PoE port switch that offers 8 10/100/1000 Mbps PoE ports, 2 10/100/1000Mbps uplink ports, auto detection and identification IEEE802.3af/at standard PD device, then carry power to it. Therefore, do not worry it will destroy the private standard PoE or NonPoE equipment. DGS-F1010P-E is the best choice for mini type commercial network because it economically
uses PoE deployment wireless AP and IP camera. It can resolve the problem of maintenance tedious, wireless coverage, terminal device powered, surveillance project. Maximum save the cost.
Powerful and flexible networking solution for small, medium, and enterprise businesses.

Simple. Easy. Smart

WebUI Web UI

Easy to use web interface to access management features.

Static Routing VLANs

Segment your network into VLANs.

Surveillance mode Surveillance Mode Interface

Get a snapshot of your security topology in an instant.

Advanced Security Features

The DGS-1100 series’ web user interface gives administrators an easy way to manage Layer 2 features, such as VLANs, Spanning Tree Protocol (STP), and link aggregation (desktop models utilize Static Trunk). With powerful security features including IGMP snooping, Static MAC, and Storm Control, these smart managed switches are a versatile solution for deployments that require easy to configure functionality without added complexities.

Simplify Network Management

D-Link’s free Network Assistant (DNA) utility displays all your connected devices and makes first-time configuration a breeze. The free D-View 7 Network Management System comes with a license for 25 nodes and 2 probes and full access to the management tools.

Full PoE Support

The DGS-1100-08PV2 supports IEEE 802.3af/at Power over Ethernet on all eight copper access ports. Power over Ethernet greatly simplifies the installation of PoE-enabled devices such as VoIP phones and IP cameras in remote locations with no immediate access to a power outlet. Each individual port has capacity to support up to 30W of PoE power, while the switch has an overall budget of 64W.

Easy Troubleshooting

The DGS-1100 Series features Loopback Detection and Cable Diagnostics to help network administrators find and solve network problems quickly and easily.
Loopback Detection detects loops created by a specific port and automatically shuts down the affected port. The Cable Diagnostics feature is designed for network administrators to quickly examine the quality of the copper cables, recognize the cable type, and detect cable errors.

Green Technology

D-Link Green technology enables the DGS-1100 Smart Managed Switches to save power without sacrificing performance. The desktop models in the series utilize a fanless design, for silent and energy-efficient operation. All models are also IEEE 802.3az-compliant and feature Link Status detection.
D-Link DGS-108. Switch type: Unmanaged, Switch layer: L2. Basic switching RJ-45 Ethernet ports type: Gigabit Ethernet (10/100/1000), Basic switching RJ-45 Ethernet ports quantity: 8. Full duplex. MAC address table: 8000 entries, Switching capacity: 16 Gbit/s. Networking standards: IEEE 802.1p, IEEE 802.3, IEEE 802.3ab, IEEE 802.3az, IEEE 802.3u, IEEE 802.3x. Power connector: DC-in jack. Form factor: Desktop
D-Link DGS-105. Switch type: Unmanaged, Switch layer: L2. Basic switching RJ-45 Ethernet ports type: Gigabit Ethernet (10/100/1000), Basic switching RJ-45 Ethernet ports quantity: 5. Full duplex. MAC address table: 2000 entries, Switching capacity: 10 Gbit/s. Networking standards: IEEE 802.1p, IEEE 802.3, IEEE 802.3ab, IEEE 802.3az, IEEE 802.3u, IEEE 802.3x. Power connector: DC-in jack. Form factor: Desktop
Price
Regular price $1,390.87
Sale price Regular price
Regular price $207.44
Sale price Regular price
Regular price $157.21
Sale price Regular price
Regular price $85.22
Sale price Regular price
Regular price $61.67
Sale price Regular price
Product variants

Special Offer

FREE SHIPPING ON ORDERS OVER $550 IN SELECTED AREAS

Explore our FAQ

Contact Us

Where do the specifications come from?

Product specifications are sourced from Icecat and displayed only when supporting data is available. Where information is missing, the field is left blank rather than populated with estimated or inferred values.

A Partnership-First Approach

At NUTEC, we take a partnership-first approach to every engagement. We start by understanding your business - its challenges, priorities, and long-term goals before recommending any technology solution. From workplace modernization and cloud infrastructure to cyber security and systems integration, our team works closely with you at every stage, ensuring the right technology is procured, implemented, and supported with clarity and confidence. We believe in transparent communication, tailored outcomes, and building lasting partnerships that grow with your business.

Opening Hours

Mon - Fri, 9:00AM - 5:00PM AEST

Phone

0401 113 232

Email

sales@nutec.com.au

Address

Online Store